Generic selectors
Exact matches only
Search in title
Search in content
Post Type Selectors

Tsurumi TRN aerators help Illinois town avoid dredging up the past

Pumps & Operations
Tsurumi TRN aerators help Illinois town avoid dredging up the past

Tsurumi TRN aerators help Illinois town avoid dredging up the past

By: Tsurumi

In 1839, a group of German immigrants decided against settling in north-central Illinois on account of its swamps and black soil, and instead chose to put down roots further south in Effingham County, about 200 miles southwest of Chicago, taking advantage of its well-drained higher lands to establish the village of Teutopolis. But 150 years or so later, town residents learned there was something deeply unpleasant lurking just beneath the surface of the “City of the Teutons.”

By 2013 a pall had begun to hang over the facultative partial-mix lagoon system that had reliably treated the wastewater from the town’s 1,530 residents since 1976. This was despite the increasingly tighter legislation that the town had adopted to control pollutant discharges and the village was still in imminent risk of noncompliance. Fortunately, AquaTec, a Rockford, Illinois-based water and energy solutions provider came to the rescue with Tsurumi TRN submersible aerators.

Not so blue lagoon

Consisting of a three-cell lagoon arrangement in series, culminating in a lagoon bottom sand filter with 6 in of fine sand above an 18-in layer of graded gravel, the town’s wastewater system was designed to handle sewage flows of up to 200,000 gpd and hydraulic loading of 5 gpd/ft. This comfortably exceeded the daily average of 111,000 gpd and the 1.5 gpd/ft or so during the implementation period.

The lagoon system worked well, and aside from an increasing sludge build-up, it had provided adequate treatment. But in 2013 the state introduced discharge limits for ammonia and nitrogen, which insisted on a maximum of 1.0 mg/l in summer and 3.3 mg/l in winter. It soon became clear that these new limits would be unachievable for the town, especially during the winter, when cold temperatures inhibit nitrifying bacteria. Aeration and some mixing would be required to meet regulations, while also improving the levels of residual dissolved oxygen in the effluent.

Cutaway of a Tsurumi TRN submersible self-aspirating aerator, designed for aeration and mixing of wastewater.

Cutaway of a Tsurumi TRN submersible self-aspirating aerator, designed for aeration and mixing of wastewater.

In an early attempt to improve the aerobic conditions, local workers installed eight floating, self-aspirating aerator units with the aim of gently mixing areas of the lagoon floor. Unfortunately, some aeration occurred within the first inches of the lagoon surface, but any mixing was extremely localized and virtually ineffective.

Municipal staff then performed a survey and discovered a 2-ft layer of accumulated sludge in certain areas throughout the lagoon, which was particularly troubling when the water depth varied from just 3 ft to 4 ft. Furthermore, residual oxygen was frequently too low to even measure.

“It seemed inevitable that we would need to initiate an immediate dredging of the lagoon,” said Jeff Strey, operations manager at AquaTec. “But after speaking with Carl Pals of the treatment plant, with all the expense and labor that had resulted from having to repair the floating aspirators several times per year, as well as the resulting loss of treatment during downtime, they were keen to avoid finding themselves in the same situation further down the line and decided to look for alternatives first.”

A reliable solution

AquaTec and partner Vandevanter Engineering, were convinced that Tsurumi’s versatile TRN aerators would be the answer. These powerful, self-aspirating aerators are designed for trouble-free, long-life operation — all wear parts are stainless steel, and any component that comes into contact with water is manufactured from cast iron or stainless steel. The bearings and the oil bath around the shaft are both oversized.

As air is drawn in from above through the suction line, water flows in from below into the area around the rotor and both are intensively mixed, ensuring the water is uniformly oxygenated. Additionally, the air flow presses the water away from the impeller, forming an air cushion that prevents the shaft seal from touching water and substantially increasing its working life.

According to Strey, inspection of a cutaway TRN unit that highlighted its robust construction was enough to persuade the municipal staff to delay dredging until three 50TRN45.5 submersible aerators were given a chance to prove themselves.

These were then placed at the bottom of the lagoon, where they could produce a “bottom up” mixing of the settled sludge (i.e., a toroidal effect) with the aim of achieving three defined goals: reducing ammonia and nitrogen levels to within permitted limits; achieving required residual dissolved oxygen levels in effluent; and reducing sludge to extend the life of the lagoon system.

A Tsurumi TRN aerator operates submerged at one of the lagoons of the Teutopolis treatment plant.

A Tsurumi TRN aerator operates submerged at one of the lagoons of the Teutopolis treatment plant.

Discharge papers

Prior to installation of the TRN units, the reported monthly BOD5 average discharge averaged 7.7 mg/l, well within the permitted discharge limit of 10 mg/l, but at a very light incoming load. Similarly, the Total Suspended Solids (TSS) loading was 60.6 mg/l, and discharge was 8.4 mg/l — again, within the permitted limit of 12 mg/l.

Unfortunately, the ammonia/nitrogen discharge average had been 17.8 mg/l, far exceeding the 1.27/3.3 mg/l seasonal limits. The discharge permit also contained a residual dissolved oxygen requirement for effluent, but the inability to nitrify the ammonia depleted that so quickly that little measurable residual dissolved oxygen could be achieved.

However, by the end of May 2020 — the same month in which the TRN units were installed — things were looking up. BOD5 effluent had decreased to 7.0 mg/l, despite the average BOD5 influent more than doubling to 84.8 mg/l. Similarly, although influent TSS had increased to 63.6 mg/l, effluent remained within discharge limits, despite the more aggressive mixing of years of accumulated sludge.

But, most crucially, with an almost tenfold reduction in ammonia/nitrogen discharge to an average of 1.88 mg/l, the treatment plant was finally on a path to meeting its permitted seasonal discharge limits. Residual dissolved oxygen could at last be routinely measured above the permit-required minimum of 5.0 mg/l, and often reached 7.0 mg/l, even in warm weather.

“Satellite images from before and after the deployment of our TRN aerators graphically show the curtailment of algae and weed growth due to nitrification of the ammonia present in the lagoon system,” Strey said. “By choosing a ‘bottom-up’ system, Teutopolis can avoid having to dredge its lagoons and also managed to easily achieve the minimum limit of 5mg/l residual dissolved oxygen. It could finally be assured of year-round BOD removal to comply with legislation.”

Teutopolis’ swamp-dodging founding fathers would surely approve.

To learn more about Tsurumi’s line of TRN submersible self-aspirating aerators, click here.

Related Articles

Netzsch Function of a Multi Screw Pump (1)

Benefits of a Multi Screw Pump

The flexible, efficient, and reliable Multi screw pumps offer a precise and reliable way of pumping the most demanding media…

Sepco Air Seal Cleans up Huge Mess

Air Seal Cleans up Huge Mess

A drywall facility experienced equipment failures, bearing problems, and major housekeeping issues before a new installation. Gypsum is a soft mineral…

Related Whitepapers

Expansion Joint Expertise Improves Industrial Wastewater System Reliability

The majority of industries have wastewater treatment plants. Government agencies and local governments require these facilities to meet pretreatment requirements. Pretreatment rules were enacted to prevent…

How to Decrease Oil Changes with Bearing Isolators [Inforgraphic]

Learning how to decrease oil changes can be time- and money-saving. Oil life can be long if contamination is eliminated, which is easier said than…

Synchronous Machines Are The Optimal Choice For Heavy Industry

TECO-Westinghouse experience assures superior performance and reliability For over a century, Westinghouse has been the pacesetter in the design and production of electric machines for heavy…

Why FLEXXORs Are Designed Differently

J. Hilbert Anderson, President of Coupling Corporation of America, discusses some of the reasons why FLEXXORs are designed differently from all other flexible couplings, and…

Comments

Leave a Reply

Your email address will not be published. Required fields are marked *

Join the #PumpTalk Community


By submitting this form, you are consenting to receive marketing emails from: Empowering Pumps & Equipment, 2205-C 7th Street, Tuscaloosa, AL, 35401, http://www.empoweringpumps.com. You can revoke your consent to receive emails at any time by using the SafeUnsubscribe® link, found at the bottom of every email. Emails are serviced by Constant Contact