For a mixer that processes 15,000 lbs. of dry pancake mix every hour, a leaking seal that requires replacement every 6 months is costly. These high costs include lost product, extensive maintenance, increased downtime and safety hazards. Multiply these losses by 10 mixers, each operating 3 shifts a day, 5 days a week, and the accumulated losses become unsustainable.

At a food manufacturing facility in Toledo, Ohio, leaking mixers were losing 830 lbs. (which is the equivalent of approximately 415 boxes of pancake mix) every week.

The facility uses mixers that have six CO2 lines for cooling the hot oil that enters the mixer as well as preventing the chocolate chips from melting. After six months of operation, the mixer’s original seals would start leaking the dry pancake mix and would need to be replaced.

An equipment analysis determined that the contact seals failed because they could not accommodate the shaft-to-bore misalignment (STBM) with tight clearances. Over a short time, wear on the seal faces caused a gap that allowed product to escape to atmosphere – making the contact seal ineffective.

Maintenance associated with the leaks added up. Each day, on each of the three shifts, plant personnel spent 20 minutes cleaning up the leaking dry mix, totaling five extra maintenance hours per week.

A bag catches pancake mix leaking from a mixer due to failed shaft seals, while additional leaking mix piles up on the ground.

All the leaked dry mix had to be thrown out, increasing product costs. Every six months, two team members spent eight hours on each mixer replacing the seals. Each seal replacement cost approximately $6,000. Over the course of the year, the failing seals created 290 man hours of work; 160 of those were also lost production hours. Additional production time was lost when conveyors shut down due to the leaking dry mix dust falling below the mixer and accumulating on the conveyor sensors.

The manufacturing plant sought a more durable solution for their mixers. They turned to Ivanne Spooner, a Technical Salesperson for Galloup and local distributor for Inpro/Seal® custom-engineered bearing protection and process seals. Ivanne suggested Inpro/Seal AM (Air Mizer®) Solutions shaft seals, which can handle STBM and shaft angularity to the housing face.

Given the seals’ ability to handle extreme amounts of shaft movement and the proven success of AM Solutions shaft seals in sealing the plant’s sugar conveyors, they decided to move forward with the upgrade.

ELIMINATING LEAKAGE WITH AN AIR SEAL

AM Solutions shaft seals seal against product loss and contamination by directing a small amount of air through a precision clearance between the seal and the shaft, pressurizing the clearance. The air is directed toward the product and atmosphere equally.

To seal the mixers, plant air was delivered to the seal at 13 psi. By using plant air, the seal avoids additional operating expense.

AM Solutions shaft seals can fully articulate to accommodate radial runout, axial movement and angular misalignment simultaneously – making this the perfect solution for the Bepex mixers. As non-contacting seals, AM Solutions shaft seals are designed to last the lifetime of the mixer.

The food manufacturing plant chose a split AM Food Grade design. The AM Food Grade design is constructed of FDA-approved materials and elastomers for use in food processing facilities and the split design allows for easy installation.

The Inpro/Seal AM Solutions shaft seal uses a positive purge of air along the shaft to permanently seal against product loss.

Since September 2014, AM Solutions shaft seals have been installed on six of the facility’s 10 mixers. After two years, they had not experienced any degradation of seal performance.

AM Solutions shaft seals are saving the plant $18,750 per mixer each year; that’s $112,500 across the six mixers installed with AM Solutions shaft seals. The last four mixers had AM Solutions shaft seals installed the second half of 2016.

Learn more about Inpro/Seal® AM (Air Mizer®) Solutions™.